Instructions for installing your new
Quick Draw Bracket on a 13cu' or 19 cu'
aluminum bottle

The first step is to coat the two screws with some form of waterproof grease.
This will keep the bolts free from corrosion and able to move freely.



Carefully insert the greased Stainless Steel screws into the threaded holes.



With bolts started one full turn, use a large
screwdriver to spread the clamp apart. This will
let you position the clamp without scratching the
paint on the bottle.



Tighten securely with 3/16" hex wrench.
Check the bottle indexing to web belt and desired
location for regulator.



Cup 2" web belt and insert into web belt bracket slot.
This will hold bracket on the belt and let you change bottles or belts easily.



Insert one pin, the one you want towards your back.
This is the swivel pin and the one you use to insert the
bottle bracket open pin hole.

Quick Draw bracket mounted with pins installed.
Shown with optional rubber pad glued in place with wetsuit glue.



Insert pins
Check belt alignment